Extron electronics Cable Cubby 1200 Installation Manual page 3

Preparing the Cable Cubby
Step 1 — Assemble Connectivity Modules.
Connectivity modules allow you to populate the Cable Cubby enclosure with a combination of AAPs, cable pass-through, or
retractors. Follow the steps below to assemble the connectivity modules of your choice.
Option 1: AAP Module
1
Secure up to three single-space
1
Secure up to three single-space
AAPs in the AAP plate.
AAPs in the AAP plate.
#4-40 Nut
#4-40 Nut
w/ Captive Washer
w/ Captive Washer
NOTE:
After assembling the module, proceed to
Option 2: Cable Pass-Through Module
3
Snap the included hole plugs into
3
Snap the included hole plugs into
any unused holes.
any unused holes.
2
Secure the grommet plate on the
2
Secure the grommet plate on the
connectivity bracket, using four
connectivity bracket, using four
of the provided module screws.
of the provided module screws.
NOTE:
After assembling the module, proceed to
Option 3: Retractor Bracket
1
Insert the bracket
into the Cable Cubby.
The bracket may be installed
on the left or right side of the
enclosure and at the lowest height.
3
3
Secure the AAP plate on the connectivity brackets,
3
Secure the AAP plate on the connectivity brackets,
using four of the provided module screws.
using four of the provided module screws.
2
Insert cables through the bottom of the connectivity bracket.
2
Insert cables through the bottom of the connectivity bracket.
Connect cables to the AAPs.
Connect cables to the AAPs.
Step 2 — Install the Modules
1
Insert cables through the bottom of the connectivity bracket
1
Insert cables through the bottom of the connectivity bracket
and into the holes of the grommet plate.
and into the holes of the grommet plate.
Step 2 — Install the Modules
2
S Secure the bracket using four of the
provided mounting screws with star washers. p
on the next page.
on the next page.
NOTE:
•
After installing the bracket, proceed to
Step 2 — Install the Modules
next page to install the power module.
•
Retractors are installed after the Cable
Cubby is mounted on the table (see
Mounting Retractors Under the Table
on page 5).
on the