Grizzly G0656P Instruction Manual page 11

4.
When correctly set, the carbide insert will just
touch the straightedge when the insert is at
its highest point of rotation (figure 2).
2
figure . using a straightedge to align the
outfeed table height with insert at tDC.
—if your outfeed table is correctly set, no
adjustments are necessary.
—if the insert lifts the straightedge off the
table or the insert is below the straightedge,
loosen the outfeed table lock and adjust the
outfeed table height with the handwheel
until the straightedge just touches an insert
at its highest point of rotation.
tip: some advanced woodworkers have found
that they can virtually eliminate snipe by set-
ting the outfeed table in the following manner:
repeat steps 1-4 using a freshly exposed
insert. place two pencil marks on the straight-
edge ⁄ " apart, and place the outward mark
5
32
on the edge of the outfeed table, as shown in
figure 3.
lower the outfeed table slightly so the insert
lifts the straightedge off the table. rotate the
cutterhead clockwise—the straightedge should
move ⁄ " toward the infeed table and the
5
32
inward mark should be directly over the edge
of the outfeed table, as shown in figure 4.
Continue adjusting the oufeed table until the
cutterhead moves the straightedge
the infeed table.
outward
Mark
figure 3. straightedge outward mark at edge of
outfeed table.
-2-
figure 4. straightedge inward mark at edge of
5.
replacing carbide inserts
tools needed:
l-Wrench torx w/t20 torx Driver ..................... 1
the cutterhead is equipped with 40 indexable car-
bide inserts. Each insert can be rotated to reveal
any one of its four cutting edges. therefore, if one
cutting edge becomes dull or damaged, simply
rotate it 90˚ to reveal a fresh cutting edge (figure
5
).
in addition, each insert has a reference mark on
⁄ " toward
5
32
one corner. as the insert is rotated, the reference
mark location can be used as an indicator of
which edges are used and which are new. When
the reference mark revolves back around to its
starting position, the insert should be replaced.
replacement carbide inserts should be included
with the cutterhead. if you need additional inserts,
call grizzly Customer service at (800) 523-4777
and order part p0452z002, replacement Carbide
insert 14x14x2mm.
inward
Mark
⁄ "
5
32
outfeed table.
lock the outfeed table, reinstall the cutterhead
guard, and close the rear access panel.
5
figure . insert rotating sequence.
g0656X Manual insert
Qty
Mark