Table of Contents
Advertisement
5
Checking the Tire Pressure
No Parts Required
Procedure
Pressure: 13 psi (90 kPa)
Note:
Check the tire pressure before starting the
machine. Refer to your Operator's Manual for the
correct tire type and procedure.
6
Charging the Battery
No Parts Required
Procedure
Important:
Do not run the machine with the
battery disconnected; electrical damage may
occur to the engine.
1.
Charge the battery; refer to the Operator's
Manual for instructions.
2.
Connect the negative battery cable.
Note:
If the positive cable is also disconnected,
connect the positive (red) cable to the positive
battery terminal first, then the negative (black)
cable to the negative battery terminal. Slip the
insulator boot over the positive terminal.
7
Raising the
Rollover-Protection System
(ROPS)
No Parts Required
Procedure
Important:
Always use the seat belt with the roll
bar in the raised position.
1.
Remove the hairpin cotters and remove the 2
pins
(Figure
2).
2.
Raise the roll bar to the upright position, install
the 2 pins, and secure them with the hairpin
cotters
(Figure
1. Roll bar
2. Raised position
3
2).
Figure 2
3. Pin
4. Hairpin cotter
g004955
Advertisement
Table of Contents
