Menu 2 - Directed Electronics Avital Installation Manual

ON
10 PANIC /Off:* When on, the panic feature can be activated at
any time from the remote and will sound for 30 seconds. When off the
panic feature does not function.
*
Not available with 1- button remote.

➢ Menu 2

1 ENGINE CHECk VIRTUAL TACH(1) /VOLTAGE(2) /OFF(3)
/TACHOMETER (4). When set to "virtual tach" (1) the remote start
monitors the cranking voltage of the vehicle and sets it as a reference
point. Fifteen seconds after the crank output sequence the remote start
checks the voltage again to determine if the vehicle is running.
When set to voltage, (2) the unit cranks the starter for the programmed
time and then attempts to sense that the engine is running by detecting
an increase in voltage. If programmed Off (3) the vehicle cranks for
the programmed crank time. The tach setting or voltage setting is not
checked to verify that the car is running. In the OFF setting, if the vehicle
fails to start, the ignition stays on for the run duration. Using tach or
either of the voltage settings is recommended.
When set to Tachometer, (4) the unit references the learned tach signal
to disengage the starter. In addition it will monitor the RPM and shut
down if the engine RPM is too high or too low.
12
2 RUN TIME— /24/60 MINUTES: This feature controls how long
the engine will run before it "times out" and shuts down. Programmed
to the default setting the engine will run for 12 minutes. If the 24 or
60 minute run time is desired, change this feature to the two or three
flash setting.
38
© 2009 Directed Electronics. All rights reserved.