Precautions - Sony SRS-XB20 Help Manual

Help Guide
Wireless Speaker
SRS-XB20

Precautions

Note when using with a mobile phone
For details on operation of your mobile phone when receiving a telephone call while transmitting the sound using the
BLUETOOTH connection, refer to the operating instructions supplied with the mobile phone.
On safety
Before operating the speaker, be sure that the operating voltage of the speaker is identical with that of your local power
supply.
Where purchased: all countries/regions
Operating voltage: 100 V – 240 V AC, 50 Hz/60 Hz
About micro-USB cables
Make sure to use the following supplied micro-USB cable.
USB Type A plug: Connects to a computer or USB AC adaptor
USB Micro-B plug: Connects to the speaker
On placement
Do not set the speaker in an inclined position.
Depending on the installation condition, it may fall over or fall. Do not place valuables, etc. nearby the speaker.
Do not leave the speaker in a location near heat sources, in a place subject to direct sunlight, excessive dust, moisture, rain,
or mechanical shock.
On operation
Do not insert any small objects, etc., into the jacks or ventilation hole on the rear of the speaker. The speaker may short out or
malfunction.
When the light is strong, brighten the room or turn off the lighting.
On cleaning
Do not use alcohol, benzine, or thinner to clean the cabinet.
Others
Two speakers are required when using the Speaker Add function. Only the SBC codec is supported while using the Speaker
Add function.
If you have any questions or problems concerning the speaker that are not covered in this Help Guide, consult your nearest
Sony dealer.
92