Sony SRS-XB20 Help Manual page 90

the BLUETOOTH mobile phone.
Switch the call device to the speaker by pressing and holding the
Adjust the volume by pressing the –/+ (volume) buttons on the speaker or operating the BLUETOOTH
3
mobile phone.
When you press the –/+ (volume) buttons on the speaker or adjust the volume on the BLUETOOTH mobile phone, the
(power) indicator flashes once in white.
When you set the volume to the maximum or minimum level on the speaker, the
white.
To end a call, press the
4
If you were listening to music before the call, playback will resume when the call ends. If you end a call by operating the
BLUETOOTH mobile phone, playback will also resume when the call ends if you were listening to music before the call.
Hint
The volume of music playback and calling is set independently in the speaker.
If the caller cannot hear or can barely hear your voice, talk more directly into the microphone of the speaker.
Note
When using the Speaker Add function or Wireless Party Chain function, sound of the phone call is output from only the speaker where the
(BLUETOOTH) indicator lights up.
The sound is output only from the right speaker during a call.
Depending on the BLUETOOTH mobile phone, playback may not pause when making a call.
Use a BLUETOOTH mobile phone at least 50 cm (1.6 ft) away from the speaker. Noise may result if the speaker and the BLUETOOTH mobile
phone are too close.
When an audio cable is connected to the AUDIO IN jack of the speaker, you cannot listen to music of the BLUETOOTH device. However, when
the BLUETOOTH connection is active, the hands-free function is available.
(call) button.
(call) button for about 2 seconds.
(power) indicator flashes 3 times in
83