Philips Lumea SC1994 Manual page 17

D Clean & store after treatment
5 Press the flash button to release a flash on your skin. The flash treats the skin
in that spot. The device makes a soft popping sound. The flash gives you a
warm sensation.
After each flash, it takes up to 3.5 seconds until the device is ready to flash
again. You can release a flash when the 'READY to flash' light lights up
white.
6 Move to an adjacent spot and press the flash button again. The surface of
the attachment that is in contact with your skin is slightly larger than the
light exit window.
Do not flash the same spot multiple times during a treatment. The surface of
the attachment should overlap the previous spot to make sure you flash the
complete skin area, but treating the same area multiple times does not
increase efficacy.
7 Continue until you have treated the full area. There are two treatment
modes (see 'Two treatment modes: Stamp & Flash and Slide & Flash').
8 Turn off the device when you finished the treatment.
9 Remove hair before every next treatment, as long as hair is still visible.
1 Unplug the device from the power outlet.
2 Let the device cool down.
3 Moisten the soft cloth supplied with a few drops of water.
17
English