Table of Contents
Advertisement
Section 3 - Configuration
Wireless Mode:
Select Wireless Client Mode from the drop-down menu.
Site Survey:
Wireless Type:
Click Site Survey to display a list of wireless networks in your
area. You may select the wireless access point to connect to.
Select Infrastructure if connecting to an access point or
wireless router, or select Ad-Hoc if connecting to another
wireless client.
Wireless Network
Enter the SSID of the access point you want to repeat the signal
Name:
of. If you do not know for sure, click Site Survey and select it
from the list, if available.
802.11 Mode:
Select the appropriate 802.11 mode based on the wireless
clients in your network. The drop-down menu options are
802.11g Only, Mixed 802.11b/g, 802.11b Only, 802.11n
Only, or Mixed 802.11b/g/n.
Wireless Channel:
The channel will automatically change to the channel of the
AP you are connected to.
Enable Auto
The Auto Channel Scan setting can be selected to allow the
Channel Scan:
DAP-1360 to choose the channel with the least amount of
interference.
Channel Width:
Select the appropriate channel width between 20MHz or Auto
20/40MHz from the drop-down menu.
Visibility Status:
Check the box if you do not want the SSID to be broadcast by the DAP-1360. This prevents the SSID from being seen by site survey
utilities, so any wireless clients will have to be pre-configured with the SSID of the DAP-1360 in order to connect to it.
Wireless MAC
You can clone the wireless MAC address to connect the device.
Clone:
Wireless Security
Select a wireless security setting. Options are None, WEP, WPA, or WPA2. See the Wireless Security section in this manual for a detailed
Mode:
explanation of the wireless security options.
WPS:
Select enable if you want to configure the DAP-1360 with Wi-Fi Protection setup.
D-Link DAP-1360 User Manual
Wireless Client Mode
38
Advertisement
Chapters
Table of Contents
