Ultrawave IND-Series Quick Manual

IND-Series Quick Guide
Please download the full instruction manual from the Ultrawave website
Electrical Safety instructions
The IND-Series Ultrasonic Cleaning Baths are designed to be connected to a
230VAC fully earthed electrical supply via a three-pin plug.
It can be dangerous to operate the Ultrasonic Bath without an earth
connected.
The IND-Series machines are rated at up to 3000W maximum.
The mains plug (BS 1363) is fitted with a 13A fuse - NEVER FIT A FUSE OF A
DIFFERENT RATING.
The mains switch is the disconnect device and should remain accessible while
the machine is in use.
Ensure that excess mains cable is stored neatly.
General Safety Instructions
Do not place fingers, hands, or other parts of the body in the liquid in the bath
when it is sonicating.
Always ensure the liquid is above the level sensor when in operation.
Do not place parts or containers directly on the bottom of the cleaning tank.
Always use a basket or instrument cassette to support items to be cleaned.
Not doing so may damage the bath and invalidate your warranty.
Never use toxic, flammable, acidic, caustic, or corrosive solutions in the bath.
Ensure the electrical supply is disconnected before moving/emptying.
Before cleaning, drain the bath. Clean by wiping with a clean non-abrasive
cloth.
full instruction manual
The user should familiarise themselves with the before
operating the equipment. Safety may be impaired if they are not followed.
Ultrawave will not be responsible for damage or injury caused by incorrect use
of the equipment.
The user should apply to Ultrawave or its agent for advice on cleaning
techniques or detergents.
July 2023 C6058701-01