Preventive Maintenance; Cleaning Agent - Randell 52365WPRM-CFA Operator's Manual

Chick-fil-a refrigerated breading table

Hide thumbs

Table Of Contents

Table of Contents

Randell strongly suggests a preventive maintenance program which would include

the following Monthly procedures:

1. Cleaning of all condenser coils. Condenser coils are a critical component in the

life of the compressor and must remain clean to assure proper air flow and heat

transfer. Failure to maintain this heat transfer will affect unit performance and

eventually destroy the compressor. Clean the condenser coils with coil cleaner

and/or a vacuum, cleaner and brush.

NOTE: Brush coil in direction of fins, normally vertically as to not damage or

restrict air from passing through condenser.

2. Clean fan blade on the condensing unit.

3. Clean and disinfect drains with a solution of warm water and bleach.

4. Clean and disinfect drain lines and evaporator pan with a solution of warm water

and bleach.

5. Clean all gaskets on a weekly if not daily basis with a solution of warm water

and a mild detergent to extend gasket life.

6. Clean the grease filter on a weekly if not daily basis with either hot water and a

mild detergent, or by cycling through a dishwasher. (See steps for removing the

grease filter on page 12.)

NOTE: DO NOT USE SHARP UTENSILS.

RECOMMENDED CLEANERS FOR YOUR STAINLESS STEEL INCLUDE THE

FOLLOWING:

JOB

Routine cleaning

Fingerprints and smears

Stubborn stains and

discoloration

Greasy and fatty acids,

blood, burnt-on foods

Grease and Oil

Restoration/Preservation

Reference: Nickel Development Institute, Diversey Lever, Savin, Ecolab, NAFEM.

NOTE: Do not use steel pads, wire brushes, scrapers, or chloride cleaners

to clean your stainless steel.

CAUTION: DO NOT USE ABRASIVE CLEANING SOLVENTS, AND NEVER

USE HYDROCHLORIC ACID (MURIATIC ACID) ON STAINLESS STEEL.