Randell 9215-32-7 Operator's Manual
  1. Manuals
  2. Brands
  3. Randell Manuals
  4. Refrigerator
  5. 9215-32-7
  6. Operator's manual

Randell 9215-32-7 Operator's Manual

Side-mount refrigerator
Hide thumbs Also See for 9215-32-7:

Advertisement

Table of Contents

OPERATOR'S MANUAL
This manual provides information on
installation, operating, maintenance,
trouble shooting & replacement
parts for
9200-32-7
SIDE-MOUNT REFRIGERATOR
NOTIFY CARRIER OF DAMAGE AT ONCE.
It is the responsibility of the consignee to inspect
the container upon receipt of same and to
determine the possibility of any damage, including
concealed damage. Unified Brands suggests that
if you are suspicious of damage to make a notation
on the delivery receipt. It will be the responsibility
of the consignee to file a claim with the carrier. We
recommend that you do so at once.
Manufacture Service/Questions 888-994-7636.
Information contained in this document is known to be
current and accurate at the time of printing/creation.
Unified Brands recommends referencing our product line
websites, unifiedbrands.net, for the most updated
1055 Mendell Davis Drive
product information and specifications.
Jackson, MS 39272
888-994-7636, fax 888-864-7636
unifiedbrands.net
04/21/2016
PP MNL0702

Advertisement

Table of Contents
loading

Related Manuals for Randell 9215-32-7

Summary of Contents for Randell 9215-32-7

  • Page 1 OPERATOR’S MANUAL This manual provides information on installation, operating, maintenance, trouble shooting & replacement parts for 9200-32-7 SIDE-MOUNT REFRIGERATOR NOTIFY CARRIER OF DAMAGE AT ONCE. It is the responsibility of the consignee to inspect the container upon receipt of same and to determine the possibility of any damage, including concealed damage.
  • Page 2 888-994-7636...

  • Page 3: Table Of Contents

    Table of Contents page 3…………………… Table of Contents & Congratulations page 4……………………………………Parts & Service Hotline page 4………………………………...…Serial Number Location page 5-9……………………..Unified Brands Limited Warranty page 10……………………………………..…Unit Specifications page 11-12…………………………………..……Unit Installation page 13-14..……………………………………..Unit Operation page 15-16……………………………..Preventive Maintenance page 17………………………………………..Electrical Diagram page 18-22..………………………………..……Troubleshooting page 23-26.…………………………….…….Replacement Parts page 27…………………………….………………………...Notes Congratulations on your recent purchase of Unified Brands food service...

  • Page 4: Parts & Service Hotline

    In addition, all Unified Brands food service equipment is backed by some of the best warranties in the food service industry and by our professional staff of service technicians. Retain this manual for future reference. NOTICE: Due to a continuous program of product improvement, Unified Brands reserves the right to make changes in design and specifications without prior notice.
  • Page 5 Warranty Policies Congratulations on your purchase of a Unified Brands Brand piece of equipment. Unified Brands believes strongly in the products it builds and backs them with the best warranty in the industry. Standard with every unit is the peace of mind that this unit has been thoroughly engineered, properly tested and manufactured to excruciating tolerances, by a manufacturer with over 30 years of industry presence.
  • Page 6 Warranty Policies (cont.) Temperature adjustments are not covered under warranty, due to the wide range of ambient conditions. To request a warranty approval number, call our Field Service Department at: 1-888-994-7636 WHEN OPTIONAL 5 YEAR COMPRESSOR WARRANTY APPLIES 1. Provide reimbursement to an ASA for the cost of locally obtained replacement compressor in exchange for the return of the defective...
  • Page 7 Warranty Policies (cont.) 5. Inbound costs on factory supplied items to be responsibility of the customer. 6. Extended warranty options are not available for parts, labor, or compressors from the factory. ITEMS NOT COVERED UNDER WARRANTY 1. Maintenance type of repairs such as condenser cleaning, temperature adjustments, clogged drains, unit leveling and re-application of silicone.
  • Page 8 Warranty Policies (cont.) CANCELLATIONS Orders canceled prior production scheduling entered into engineering/production and cancelled are subject to a cancellation charge (contact factory for details). STORAGE CHARGES Unified Brands makes every effort to consistently meet our customer’s shipment expectations. If after the equipment has been fabricated, the customer requests delay in shipment, and warehousing is required: 1.
  • Page 9 Warranty Policies (cont.) RETURNED GOODS Authorization for return must first be obtained from Unified Brands before returning any merchandise. Any returned goods shipment lacking the return authorization number will be refused, all additional freight costs to be borne by the returning party. Returned equipment must be shipped in original carton, freight prepaid and received in good conditions.

  • Page 10: Unit Specifications

    Unit Specifications 9205-32-7M UNIT SHOWN STORAGE SHELVES MODEL DOORS VOLT AMPS NEMA SHIP WT CU FT CU FT 9215-32-7 48” 33” 36” (2) 18” 11.58 115/60/1 5-15P 9205-32-7 60” 33” 36” (2) 24” 16.21 13.5 115/60/1 5-15P 9235-32-7 72” 33”...

  • Page 11: Unit Installation

    Unit Installation SELECTING A LOCATION FOR YOUR NEW UNIT The following conditions should be considered when selecting a location for your unit: 1. Floor and Countertop Load: The area on which the unit will rest must be level, free of vibration, and suitably strong enough to support the combined weights of the unit plus the maximum product load weight 2.
  • Page 12 Unit Installation (cont.) NOTE: All self-contained models are shipped from the factory with the service vales open and ready for operation. NOTE: FAILURE TO FOLLOW INSTALLATION GUIDELINES AND RECOMMENDATIONS MAY VOID THE WARRANTY ON YOUR UNIT. ELECTRICAL SUPPLY: Any wiring should be done by a qualified electrician in accordance with local electrical codes.

  • Page 13: Unit Operation

    Unit Operation Allow unit to operate for approximately two (2) hours before placing in food. AMBIENT CONDITIONS 1. This unit is designed for operation in a room ambient of maximum 86°F and 55% relative humidity or less. It should never be used outside or located in direct sunlight.
  • Page 14 Unit Operation (cont.) DOOR ADJUSTMENT The doors are mounted to the cabinet with two screws on the upper hinge, and a hinge pin on the bottom. To adjust the door, first open it to 90º and loosen the two screws enough to reposition the door. Once repositioned, retighten all screws.

  • Page 15: Preventive Maintenance

    Preventive Maintenance Unified Brands strongly suggests a preventive maintenance program which would include the following Monthly procedures: 1. Cleaning of all condenser coils. Condenser coils are a critical component in the life of the compressor and must remain clean to assure proper air flow and heat transfer.
  • Page 16 Preventive Maintenance (cont.) NOTE: Do not pressure wash equipment as damage to electrical components may result. Proper maintenance of equipment is the ultimate necessity in preventing costly repairs. By evaluating each unit on a regular schedule, you can often catch and repair minor problems before they completely disable the unit and become burdensome on your entire operation.

  • Page 17: Electrical Diagram

    Electrical Diagram Unifiedbrands.net...
  • Page 18 Trouble Shooting Guide SYMPTOM POSSIBLE CAUSE PROCEDURE Unit does not run No power to unit Plug in unit Power switch in OFF position Switch power switch to ON Temperature control turned off Check temperature control Temperature control faulty Test temperature control Compressor overheated Clean condenser coil Condenser fan faulty...
  • Page 19 Trouble Shooting Guide (cont.) Moisture around door Breaker strip faulty Inspect strips Call for service at 888-944-7636 or frame Frame heater faulty Temperature control set too low Adjust control to raise setting Ice in drain pain or Drain tube clogged Clean drain water in bottom of unit Unit not level...
  • Page 20 Trouble Shooting Guide (cont.) CHECKING THE DOOR SEAL: Open the door and examine all four sides of the door gasket for any tears. Feel the gasket for brittleness and/or cracks. If the gasket shows damage, then it must be replaced. If no damage is observed, close the door and check the seal between the gasket and the cabinet for obvious gaps.
  • Page 21 Trouble Shooting Guide (cont.) SERVICING THE COMPRESSOR: The compressor is part of the sealed refrigeration system and should be replaced by a professional service technician. You can, however, test the compressor and certain components. Prior to testing, unplug the unit and remove the access cover to the mechanical housing.
  • Page 22 Trouble Shooting Guide (cont.) For testing the compressor, use a multimeter set at RX1 to test each of the three terminal pins against each of the other two terminal pins. Each pair should show continuity. Then, with the multimeter set at RX1000, place one probe against the metal housing of the compressor (if necessary, scrape off a small amount of paint to ensure contact with bare metal).

  • Page 23: Replacement Parts

    Replacement Parts Call factory for replacement parts. Unified Brands Service and 888-944-7636 Parts Hotline ITEM DESC 9205-32-7 9215-32-7 9225-32-7 9235-32-7 DOOR HINGE - LEFT RP HNG9902 RP HNG9902 RP HNG9902 RP HNG9902 DOOR HINGE - RIGHT RP HNG9901 RP HNG9901...
  • Page 24 Replacement Parts (cont.) ITEM DESC 9205-32-7 9215-32-7 9225-32-7 9235-32-7 EXTERIOR SIDE BASE T07-1006 T07-1006 T07-1006 T07-1006 REFRIGERATOR DOOR REFER TO PG 25 REFER TO PG 25 REFER TO PAGE 25 REFER TO PG 25 LOUVER PANEL T07-1025A-D17 T07-1025A-D17 T07-1025C-D17 T07-1025B-D17...
  • Page 25 Replacement Parts (cont.) ITEM DESC 9205-32-7 9215-32-7 9225-32-7 9235-32-7 SHELF CLIP HD CLP100 HD CLP100 HD CLP100 HD CLP100 SHELF SUPPORT BRACKET T07-1501A T07-1501A T07-1501A T07-1501A THERMOMETER HD THR100 HD THR100 HR THR100 HD THR100 WIRE SHELF HD SHL060 HD SHL015...
  • Page 26 Replacement Parts (cont.) ITEM DESC 9205-32-7 9215-32-7 9225-32-7 9235-32-7 EVAP SHROUD GUARD T07-1504C T07-1504C T07-1504C T07-1504C RF FAN1401 RF FAN1401 RF FAN1401 RF FAN1401 EVAP FAN SHROUD T07-0528-D17 T07-0535-D17 T07-0528-D17 T07-0528-D17 EVAP HOUSING RP HSG0801 RP HSG0801 RP HSG0801 RP HSG0801...

  • Page 27: Notes

    NOTES Unifiedbrands.net...

This manual is also suitable for:

935-32-79205-32-79225-32-79200-32-79205-32-7m

Table of Contents