CV-401 / CV-801 / CV-1601 Installation Figure 1. Installing the bracket to the KVM. Figure 2. Fixing the KVM into the rack. PS/2 DB-15 KVM screw A: M3.2 x 4.5 mm screw B: M4 x 10 mm ■ Install each bracket using screws pro- vided shown in Figure 1.
Page 3
Package Content (only for rackmount KVM) KVM switch x 1 pc Screw M3.2 x 4.5mm x 4 pcs Screw M4 x 10mm x 8 pcs Bracket x 1 set User manual x 1 pc Power cord x 1 pc PS/2 DB-15 KVM...
Cascade ■ With the CV-401 cascade up to 116 servers. With the CV-801 cascade up to 120 servers. With the CV-1601 cascade up to 128 servers. ■ Cascading multiple KVM by CA-6 cable Cascade Rackmount KVM Local Console Cascade Cascade...
Page 6
Turn off all servers and KVM switches ■ Make sure all cables / connectors are properly connected ■ Recommend Power ON sequence is monitor, KVM switch fi nally computer Front Panel - Port LED Indications 4 ports (only for CV-401)
Page 7
Password Password for CV-401 / CV-801 / CV-1601 The password is enabled by default, the default password is “00000000” eight zeros (Do not use “0” on number pad) ■ Set your own user name & password Call KVM OSD menu by pressing the KVM hotkey Select “CHANGE PASSWORD”...
KVM OSD OSD Menu for CV-401 / CV-801 / CV-1601 OSD operation next to the system name next to the system name SCAN CHANGE PASSWORD Console ON/OFF PgUp / PgDn ENTER INSERT The PC is powered on The PC is selected...
CV-401 : 443 x 200 x 44 mm / 17.4 x 7.9 x 1.73 inch CV-801 / CV-1601 : 443 x 180 x 44 mm / 17.4 x 7.1 x 1.73 inch CV-401 / CV-801 : 3.5 kg / 8 lb CV-1601 : 4 kg / 9 lb 510 x 400 x 77 mm / 20.1 x 15.7 x 3 inch...
Page 13
General How do the KVM switches allow the user to switch ports? There are two ways to switch ports. One is the membrane buttons on the front and the other way is with Hot-key commands. What operating systems do the KVMs support? The KVMs support multi-platform support allows you to control Windows-based computers, Sun So- laris systems, Linux, or even Macs by a single KVM switch.
Page 14
The problem may come from the power on sequence. For KVM switch The recommended power on sequence is - monitor, KVM switch and then servers. For remote console box It supports DDC function but does not support hot-plug, the recommend power on se quence is –...
The LED on the Cat5 dongle will fl ash when plugged into the USB or USB server. The light will then become steady when the KVM switch has connected. If the LED light is on and not fl ashing when plugged into server, please unplug the USB or PS/2 and try again.