Advertisement
2. LED DISPLAY (Problems Shown on LED Indicator Combination)
Status of Indicator Light
Error
Cord
FAN
TEMP
No.
00
(OFF)
(OFF)
01
(GREEN)
(OFF)
02
(GREEN)
(OFF)
03
(GREEN)
(OFF)
04
05
(GREEN)
(Orange)
06
(GREEN)
(RED)
(Orange
07
(GREEN)
flashing)
09
(OFF)
(RED)
(Orange
10
(OFF)
flashing)
(RED
11
(OFF)
flashing)
12
(GREEN)
(OFF)
(GREEN)
13
(Orange)
NOTE
In each mode shown with this color, the projector returns to the standby mode after error indication for about
2 minutes.
LAMP
ON
Standby-power is not on
> There's a problem with the
(OFF)
(OFF)
The lamp went out
(RED)
(RED)
during use or the lamp
will not switch on
> The bulb has reached
(RED
the end of it's life.
(RED)
flashing)
The power turns off
(Orange
(RED)
>Trouble with the Lamp
flashing)
cover
The power turns off or
does not come on
(OFF)
(RED)
> The inside is too hot, or
(OFF)
(RED)
Error Cord
05: Near the Lamp housing
06: Near the Intake fan
(OFF)
(RED)
07: Polarized filter
The power turns off or
(OFF)
(RED)
does not come on
> Trouble with the cooling
fans.
(OFF)
(RED)
Error Cord
09: Lamp fan
10: Exaust fan
(OFF)
(RED)
11: Intake fan
The power turns off
(Orange)
(RED)
> System micon error.
Error Cord
12: Device Error
(GREEN)
(RED)
13: Status Error
2-2
Cause and Trouble
power unit or system
microcomputer.
the projector has been
working in an area of
high temperature.
Solution
Check the power unit.
Check the connector.
Check the main PC board.
Change new lamp.
There may also be trouble in
ballast power supply.
The lamp cover is not properly
attached. Unplug the power
cord and reattach the lamp cover.
Place the projector correctly
so the intake and exhaust fan's
holes are not covered.
Turn the projector off, and
leave it for a while, and turn it
on again.
Clean the air filter.
Check the each cooling fan.
Wait for two minutes, and
turn on the power again.
Advertisement
