Table of Contents
Advertisement
Remove screws,
lift top cover.
Top Cover
Cap
Chimney
TR11/TR11T
TR444/TR442
Round Termination Cap
Figure 4.1
Chimney & Termination Cap Cleaning
C. Grate
Frequency:
After each ash removal
By:
Homeowner
Inspect grate for:
•
Warping or sagging 1-1/2 in. (38 mm) or more
•
Broken welds
•
Burn-through of grate bars
For safe operation, replace only with the approved grate
from Hearth & Home Technologies
D. Glass Cleaning
Frequency:
As necessary
By:
Homeowner
Tools
Needed: Vinegar or glass cleaner, soft towel
•
Clean glass with a non-abrasive glass cleaner. Use a
damp cloth dipped in wood ashes or a commercially
available oven cleaner. Remove any oven cleaner
residue with a glass cleaner or soap and water.
Remove 4 screws
and lift top pan off.
Cap
Slip
Section
ST1175
ST475
Square Termination Cap
Majestic Biltmore Series • SB60/SB80 Owner's Manual • 4013-301 • Rev F • 02/20
Remove 2 screws from
the front and back and
lift the top off.
SCREW
TCT1175
Terra Cotta
Termination Cap
Available US only
E. Ash Removal
Frequency:
As necessary
By:
Homeowner
Tools
Needed: Covered metal container, metal
shovel, fireplace broom
WARNING! Risk of Fire! DO NOT remove ashes until
the fire is out and the fireplace is cold.
•
Ashes should be placed in metal container with tight
fitting lid.
•
The closed container of ashes should be placed
on a noncombustible floor or on the ground, well
away from all combustible materials, pending final
disposal.
•
If the ashes are disposed of by burial in soil or
otherwise locally dispersed, they should be retained
in the closed container until all cinders have
thoroughly cooled.
F. Refractory
Frequency:
After each ash removal
By:
Homeowner
•
Inspect condition of refractory. Replace if crumbly or
otherwise deteriorated, metal is exposed behind the
refractory, or if cracks exceed 1/4 in. (6 mm).
1. REMOVE (8) SCREWS
2. LIFT TOP
TOP
TOP
SCREW
DT SERIES
15
Advertisement
Table of Contents
