Pioneer Elite VSX-LX301 Basic Manual page 46

> Specifications > Specifications > Settings > Settings > Listening Modes > Playback Function
■ Volume
Setting Item Default Value
− dB
Mute Level
Volume Limit Off
Power On Level Last
Headphone Level 0.0 dB
14 14
> Listening Modes > Playback Function
Setting Details
Set the volume lowered from the listening volume
when muting is on. Select a value from "− dB",
"−40 dB", and "−20 dB".
Set the maximum value to avoid too high volume.
Select "Off" or a value between "−32 dB" and "＋
17 dB".
Set the volume level of when the power is turned
on. Select a value from "Last" (volume before
entering standby mode), "− dB", and "−81.5 dB"
to "＋18.0 dB".
• You cannot set a higher value than that of
"Volume Limit".
Adjust the output level of the headphones. Select a
value between "−12.0 dB" and "＋12.0 dB".
Source
Make settings for input sources, such as volume difference adjustments for each input
selector for the connected equipment.
■ Input Volume Absorber
Adjust the volume level difference between the devices connected to the unit. Select the
input selector to configure.
Setting Item Default Value
Input Volume 0.0 dB
Absorber
■ Name Edit
Set an easy name to each input. The set name will be shown on the main unit display.
Select the input selector to configure.
Setting Item Default Value
Name Edit Input name
> Basic Manual > Basic Manual
Troubleshooting Appendix Troubleshooting Appendix
Setting Details
Select a value between "−12.0 dB" and "＋12.0
dB". Set a negative value if the volume of the target
device is larger than the others and a positive
value if smaller. To check the audio, start playback
of the connected device.
• This function is not effective in Zone 2.
Setting Details
1. Select a character or symbol with the cursors
and press ENTER.
Repeat it to input 10 or less characters.
"A/a": Switches between upper and lower
cases. (Pressing MODE on the remote
controller also toggles between upper and
lower cases)
"←" "→": Moves the cursor to the arrow
direction.
" ": Removes a character on the left of the cursor.
" ": Enters a space.
• Pressing CLEAR on the remote controller
will remove all the input characters.
2. After inputting, select "OK" with the cursors and
press ENTER.
The input name will be saved.
| |