Table of Contents
Advertisement
Troubleshooting
1. After the installation, there is no tyre data on the display
* The sensors were not programmed to the display, please program the
sensors
* The display should show the real time tyre data automatically when the
speed is over 25km/h
* There is a problem with the sensor
2. "--" appears intermittently on the display unit.
* The signal that is transmitted is a RF signal and is much like a mobile
phone signal. The ACMA allows for other RF signals to interfere with
the system signals and this can cause the monitor to occasionally miss
a transmission from the sensors. If this persists then you could have a
damaged sensor or the batteries could be weak.
Additional Warnings
• These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
• This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
• However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio technician for help.
WARNINGS
23
Advertisement
Table of Contents
