Table of Contents
Advertisement
Initial set-up of your oven
Setting the time of day
o When the oven is connected to your mains supply for the first time
(or after a power cut), the digits on the LED display (7) will show
"0:00" and there will be an audible signal.
o Press the clock button (3) and the hour digits will flash on the LED
display.
o Turn the adjustment knob (6) to adjust the hour time. Your oven
has a 24 hour clock, so it is possible to adjust the hour digit
between 0 and 23.
o When the correct hour time appears on the LED display, press the
clock button again. The minute digits will flash
o Turn the adjustment knob to adjust the minute time; it is possible
to adjust the minute digit between 0 and 59.
o When the correct minute time appears on the LED display, press
the clock button for a third time
The ":" symbol between the digits will flash and the time of day wil
o
light on the LED display.
IMPORTANT: You can adjust the time o
following the
instructions above, as lon
currently in us
Before first use
To remov
e any residue from the oven that may have been left from
o
the manufacturing process, you should select the convection & fan
oven function and set the thermostat to its maximum temperature
setting.
It is perfectly normal for a s
o
o You should make sure that any windows in the room are left open
during this process.
o It is advisable for you not to remain in the room whilst the burning
off proces
s is taking place.
o You should leave the oven on maximum setting for 30 – 40
minutes.
o After the oven cavity has cooled, it should then be cleaned with
warm soapy water, using either a sponge or soft cloth. No abrasive
cleaner
s should be used.
to confirm the time of day.
e.
mell to be produced during this process.
on the LED display.
f day at any time by
g as the oven is not
l
11
Advertisement
Table of Contents
