Installation Method - Breeze MFD Series User Manual

We bring better air to life

7. INSTALLATION METHOD

• The fan is suitable both for horizontal or vertical mounting on the
wall or on the ceiling (Fig. 01- 03) as one unit or included into
connected in parallel or in series sets (Fig. 04, 05).
• In case of the horizontal fan mounting install a straight air ducts
segment on side of the intake vent not less than 1m.
Fig 05
• In case of the vertical fan mounting
install an outer hood to prevent water
ingress inside the fan.
• The exhaust spigot must be connected
to the air duct.
• The fan mounting sequence is shown
in Fig. 06 - 12.
Fig 09
8. OPERATION INSTRUCTION
Visual Inspection of Equipment
• The equipment type and arrangement should be verified as ordered at once when it arrives at the jobsite. When a discrepancy
is found, the local Breeze Sales Representative must be notified immediately so that corrective action may be investigated,
also verify electrical conformance to specifications. Unauthorized alterations and unauthorized backcharges will not be
recognized by Breeze Fan.
• After the unit has been assembled, installed and all utilities have been hooked up, the unit is now ready for operation.
Check
Before starting the unit, check the following:
• Confirm that building supply voltage matches the voltage for which the unit is wired.
• Check all piping and wiring penetrations
• Made by contractors for water tightness. All penetrations must be made watertight to prevent water damage to the unit and
building.
• Rotate the fan impeller manually to be sure that it is free to operate. Remove any dirt or debris that may have accumulated
during installation.
• Inspect all fasteners to ensure that none have loosened during shipment.
• Check all electrical connections for proper attachment.
• Check casing and ductwork, if accessible, for obstructions and foreign material that may damage the fan impeller.
www.breeze.com.vn | breezefans@breeze.com.vn
Fig 04
Fig 06
Fig 10
USER'S MANUAL
Airflow
min 1m
Fig 03
Fig 07
Fig 11
MFD SERIES
Fig 01
Airflow
Fig 02
Fig 08
Fig 12
04