Table of Contents
Advertisement
References
Location of Controls
Back Panel
3 CH. 4 Switch
Selects the channel to which you will tune the TV
to see the VCR picture if you connect the VCR
using one of the basic hookups.
IN FROM ANT. (Antenna) Connector
Receives a signal from an antenna or cable system
when attached.
OUT TO TV Connector
Passes signal to TV using the cable supplied.
S-VIDEO OUT and IN Connectors
Lets you attach another S-VHS component to the
S-VIDEO IN connector using the included S-VHS
cable. Use INPUT on the remote to display L1 in
the VCR's display panel to select.
Lets you attach the S-VIDEO OUT connector to a
TV monitor having an S-VIDEO IN connector to
take full advantage of the S-VHS format.
Also, remember to attach the audio jacks. The
S-VHS cable carries only video.
IN FROM
ANT.
AUDIO1
VHF/UHF
OUT
L
R
OUT TO TV
3 CH. 4
IN
VIDEO1 and AUDIO1 (R and L) IN Jacks
Receives signals from another component, such as
a VCR or camcorder, when it is connected to these
jacks.
Display L1 in the VCR's display panel using
INPUT on the remote to select these jacks.
VIDEO1 and AUDIO1 (R and L) OUT Jacks
Sends signals from VCR to another component,
such as a monitor TV or another VCR, when it is
connected to these jacks.
If the other component is not stereo, you may need
a Y-adapter to hear both channels.
OUT
VIDEO1
IN
S-VIDEO
43
Advertisement
Table of Contents
