Table of Contents
Advertisement
Hooking Up the VCR
Cable System With Cable Box to Unscramble Only Pay Channels
(such as HBO, Showtime, Pay-Per-View, etc.)
Position Cable Box
Position the remote-controllable cable box on
top of the VCR. You may need to position it
at different angles before the VCR can
control it. Make sure the cable box does not
cover the transmitting window on top of the
VCR.
A. Basic hookup.
Use this hookup for a simple connection
which requires fewer accessories.
1. Set the 3 CH. 4 switch on back of VCR to
either channel 3 or 4.
Tune the TV to this channel and use the
TV•VCR button to watch the VCR.
2. Connect as shown.
This connection may require additional
accessories not provided.
3. Plug in power cords of VCR, TV, and
cable box.
4.
Continue to page 10.
B. Advanced hookup.
Use this hookup for slightly improved
picture quality and more convenient
operation — use of the TV•VCR button is
not required.
1. Connect as shown.
This connection requires additional accessories
not provided.
If your TV/monitor has an S-VIDEO connector,
also connect the supplied S-VHS cable to take
advantage of S-VHS.
If your TV is not stereo, you may need a
Y-adapter to hear sound from both channels.
2. Plug in power cords of VCR, TV, and
cable box.
Continue to page 10.
3.
Tune the TV to its video input to watch the
VCR. View all pay channels through the VCR.
Transmitters
A
From Cable
Cable Box
IN
OUT
B
From Cable
Signal
Splitter
RF Coaxial
Cable
(supplied)
Cable
Box
Back of VCR
RF Coaxial
Cable
IN FROM
AUDIO1
ANT.
OUT
VHF/UHF
R
OUT TO TV
3 CH. 4
IN
RF Coaxial Cable
(supplied)
OR
Cable/
Antenna
Back of TV
Cable Box
IN
OUT
RF Coaxial Cables
Back of VCR
IN FROM
AUDIO1
VIDEO1
ANT.
OUT
VHF/UHF
R
L
OUT TO TV
3 CH. 4
IN
Audio/Video Cables
VIDEO
INPUT
RIGHT
OUT
AUDIO
IN
CABLE /
L /
ANTENNA
MONO
Back of TV
Remote Sensor
VIDEO1
OUT
IN
L
S-VIDEO
75 to 75/300 Ohm
Separator
VHF
UHF
OUT
S-VIDEO
S-VHS
Cable
S-VIDEO
5
Advertisement
Table of Contents
