Manual Clock Set - RCA VR689HF User Manual

Setting Up the VCR
Startup
D. Press MENU•PROG on the remote if all antenna or cable

Manual clock set.

If the AUTO CLOCK SET was unsuccessful:
A. Press 1 to display the SET TIME AND DATE screen.
B. Enter the time and date with the number buttons on the
C. Press MENU•PROG on the remote to remove the SET TIME
If you ever need to reset the clock:
A. Press MENU•PROG on remote to display the VCR MAIN
B. Press 3 to display the TIME menu.
C. Press 1 to display the SET TIME AND DATE screen.
If you set the clock manually, Auto Clock Set will be set to OFF.
connections are completed. Auto Channel Search will be
performed followed by automatic clock set.
If The Auto Clock Set was unsuccessful message appears, you
can press 1 to set the clock manually or try auto clock set again.
The clock must be set before you can use the timer recording
feature.
SETUP
The Auto Clock Set
was unsuccessful.
Would you like to set
the time and date?
1 Set Time and Date
2 Skip this step
Try Auto Clock Set Again: If you think there is a local station
(usually PBS) broadcasting the XDS (time) information, make
sure the Auto Clock Set feature is set to ON on the TIME menu
(press 2 to exit SETUP, press MENU•PROG to display the VCR
MAIN MENU, press 3 to display the TIME menu, and press 2 to
turn the Auto Clock Set feature ON). Tune the VCR to the
channel you believe is broadcasting the information, then turns
off the VCR. If the time does not set within ten minutes, XDS
information is not available. Set the time and date manually.
Set Clock Manually: Press 1 and follow the directions below to
manually set the clock.
remote.
¥ Press 0 before single-digit numbers.
Example: press 0, then 5, then 0, then 7 for a time of 5:07.
Press 1 for AM or 2 for PM.
¥ Press CLEAR on the remote to change incorrect entries.
AND DATE screen from the TV screen and start the clock.
The time will appear in the VCRÕs display panel and the time
and date will appear on the TV screen when you press
DISPLAY.
MENU on the TV screen.
Make sure all antenna
connections to the VCR
are complete.
Press MENU when ready
SETUP
The VCR is now setting
the clock. This may
take several minutes.
Press MENU to cancel
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Time
4 Channels
5 Setup
6 Preferences
7 Language/Langue
8 Audio
0 Exit
TIME
1 Set Time and Date
2 Auto Clock Set: OFF
3 Set Time Zone
4 Set Daylight Savings
0 Exit
SET TIME AND DATE
Time --:--
(hh:mm)
Date --/--/--
Press MENU to exit
15