Kenmore 233.5139 Series Use & Care / Installation Manual page 8

3. Remove the wiring cover (shaded part on illustration
beside) by sliding it out from the hood and set it aside.
4. Remove 7" Round Duct Plate from top/back of hood (see
illustration beside).
5. Remove Electrical Power Cable Knockout from top
(vertical exhaust) or back (horizontal exhaust) of
hood. Install an appropriate strain relief, 1/2" diameter
(not included).
6. Remove 3 screws retaining the recirculation cover plate
(shaded part in illustration beside) to the hood. Discard
this plate with its screws.
NON-DUCTED INSTALLATIONS ONLY
2 SCREWS
ELECTRICAL
POWER CABLE
KNOCKOUT
RECIRCULATION
COVER PLATE
8
7" ROUND
DUCT PLATE
SCREWS