Kenmore 233.5139 Series Use & Care / Installation Manual page 12

FRAMELESS CABINET
Refer to the marking on the brackets to determine the
correct installation side and orientation.
7/64"
3 X

Align the corresponding bracket to the cabinet side,
while placing rear end of bracket against the wall.
Draw a line on the outer edge of the bracket (as shown).

Slide the bracket towards the center of cabinet and
align the outside edge of the bracket with the marked
line, keeping the rear end edge leaning on the wall.

Use a pencil to mark 3 holes.

Remove the bracket. Using a 7/64" drill bit, drill 3 holes
where marked.

Assemble the bracket to the cabinet bottom using a
Phillips screwdriver and 3 provided countersunk wood
screws. Repeat for the other cabinet side
.
12