Kenmore 233.5139 Series Use & Care / Installation Manual page 11

4. Drill a 1/8" dia. pilot hole for house wiring,
at A location on template.
5. Use a sharp pencil or 1/8" drill bit to mark the loca-
tions for the appropriate duct access holes (16 locations
for 7" round duct, or 4 corner locations for rectangular
duct). Remove the template.
FRAMED CABINET
Refer to the marking on the brackets to determine the
correct installation side and orientation.

Mate the corresponding bracket to the cabinet side
frame, while placing rear end of bracket against the
wall. Use a pencil to mark 3 holes (there are 6 holes
but only 3 are necessary).

Remove the bracket. Using a 7/64" drill bit, drill 3 holes
where marked.

Assemble the bracket to the side frame using a Phillips
screwdriver and 3 provided no. 8 x 5/8" wood screws.
Repeat for the other side frame.
6. Draw the border for the exhaust ducting by linking its
marks (16 for round duct and 4 for rectangular duct), then
cut the opening in the cabinet bottom (vertical exhaust)
or in the wall (horizontal exhaust). Drill the house wiring
hole by using a 1½" hole saw centered with the pilot hole
previously made in 4.
7. Install the proper installation brackets according to the
type of cabinet (framed or frameless). See below.
7/64"
11