Preparation; Unpacking The Tv - JVC LT-43C890B Instruction Manual

43" led smart 4k hdr tv

Hide thumbs

Table Of Contents

Table of Contents

Chapter

Preparation

Thank you

Your new TV has many features and incorporates the latest technology to enhance your viewing

experience. We recommend that you spend some time reading this instruction manual so that you fully

understand these features. You will also find some hints and tips to help you resolve any issues.

Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Unpacking the TV

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.

The following items are included:

TV Stand Neck

Instruction Manual

43" LED Smart 4K HDR TV

LT-43C890(B)

Instruction Manual

JVC 43' LED Smart 4K HDR TV LT-43C890(B) Manual.indd 7

for purchasing your new JVC TV.

Stand screws x8

TV Stand Base

Thank you

Your new TV incorporates the latest technology to enhance your viewing

experience. We would suggest that you allow about 15 mins for initial setup.

Please follow this guide for a successful first time installation.

Setup in

What's in the Box?

Quick Start Guide

15mins

Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.

43" LED Smart 4K HDR TV

TV Stand Neck

TV Stand Base

LT-43C890(B)

Operating Your Remote Control

1. Slide open the battery compartment on the back of the remote control.

2. Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of

the batteries with the (+) and ( - ) ends indicated in the battery compartment.

3. Slide the battery compartment cover back into place. Make sure it clicks into place.

For extra safety use the screw supplied to screw the battery compartment closed.

Installing the Base Stand

Fitting the Stand Neck and Base Together

1. Fit the neck onto the base.

2. Using 4 of the supplied screws, screw the neck to the base.

Fitting the Stand to the TV

1. Ensure the TV is switched off and not connected to the mains power supply.

2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly

overhangs the edge of the table, with the back side facing up. Please make sure a soft cushioned

material (such as a dry bath towel or thick piece of foam) is placed beneath the screen.

3. Slide the stand under the lip, the neck will fit snugly over the screw holes. Then screw the stand to

the TV using the 4 screws supplied.

Protective

Bag

The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object, or

anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because the

screen could crack.

JVC 43' LED Smart 4K HDR TV LT-43C890(B) Quick Start.indd 1-3

Quick Start Guide

Remote Control /

AAA Batteries x 2

for purchasing your new JVC TV.

The latest eco-friendly power-saving technology will switch off the TV if

it is left on and idle for 4 hours. Please refer to "Auto Standby" under the

Connecting the Aerial and Turning on the TV

"Time Settings" section of the instruction manual for more detail.

1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on the back of your TV.

2. Plug the TV into a mains socket and switch on at the mains.