Table of Contents
Advertisement
Chapter
2
Preparation
2
Thank you
Your new TV has many features and incorporates the latest technology to enhance your viewing
experience. We recommend that you spend some time reading this instruction manual so that you fully
understand these features. You will also find some hints and tips to help you resolve any issues.
Read all the safety instructions carefully before use and keep this instruction manual for future reference.
Unpacking the TV
Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
TV
GB
Instruction Manual
32" HD-Ready LED TV with DVD
LT-32C345(C) / LT-32C346(C)
Instruction Manual
for purchasing your new JVC TV.
Stand screws x4
TV Stand
Quick Start Guide
32" HD-Ready LED TV
with DVD
LT-32C345(C) / LT-32C346(C)
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance your viewing
experience. We would suggest that you allow about 20 mins for initial setup.
Please follow this guide for a successful first time installation.
The latest eco-friendly power-saving technology will switch off the TV if
device is left on and idle for 4 hours. Please refer to "Auto Standby" under
the "Time Settings" section of the instruction manual for more detail.
1
Unpacking
TV
R emote Control/
Instruction Manual
Remove all packaging from the unit. Retain the packaging.
AAA Batteries x2
TV Stand
Quick Start Guide
If you dispose of it please do so according to any local regulations.
Screws x 4
2
Operating Your Remote Control
1. Remove the screw and open the
2. Insert two AAA size batteries. Make
3. Replace the battery compartment
battery compartment.
sure to match the (+) and ( - ) ends
cover, make sure it clicks into place
of the batteries with the (+) and
then replace the screw..
( - ) ends indicated in the battery
compartment.
3
Installing the Base Stand
1. Ensure the TV is switched off and not connected to
the mains power supply.
2. Lay the TV down on a flat surface ideally on the edge
of a table so the base of the TV slightly overhangs
the edge of the table, with the back side facing up.
Please make sure a soft cushioned material (such as
a dry bath towel or thick piece of foam) is placed
beneath the screen.
3. Slide the stand under the lip, the neck will fit snuggly
Slide under
Slide under
over the screw holes. Then screw the stand to the TV
the lip
the lip
using the 4 screws supplied.
Cushioned
Table
material
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object,
or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because
the screen could crack.
LT-32C345_46(C)_QSG.indd 1
Quick Start Guide
4
Connecting the Aerial and Turning on the TV
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the
other end of the cable to the ANT socket on the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the button on the remote control to turn the TV on.
The red LED indicator will flash for a few seconds then the TV will switch on.
VGA
SPDIF
SCART
RF coaxial cable
(not included)
• Do not connect the TV to the mains supply until you have completed all the connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove the mains plug from the mains socket.
5
Tuning in the TV
Choose Region
1. The first time you turn the TV on, it will go
6. Confirm these settings by pressing OK.
straight into the First Time Installation
7. Press the buttons to highlight Home
menu. Please ensure the aerial is plugged in.
During tuning, your TV may have received
Mode then press OK.
Press the
buttons to highlight your
signals from more than one transmitter. If this
language then press OK.
has occurred the Choose Region screen will be
displayed. This will enable you to select the
correct regional transmission for the local news
First time installation
service that you require.
Welcome please select your language!
English
If the TV is to be used in a store, please select the Store Mode. For domestic use,
Bienvenue ! Veuillez choisir une langue.
Francais
Home Mode is recommended.
1. Press the button to highlight Primary
Willkommen, Wahlen Sie bitte lhre Sprache aus!
Deutsch
Benvenuti, Selezionate la vostra lingua!
Italiano
Home Mode
Store Mode
region, then press the buttons to select
Bienvenido, seleccione un idioma
Espanol
your Primary Region e.g. England.
Hos geldiniz, lutfen dil secimini yapiniz!
Turkce
Dobrodosli, izberite vas jezik!
Slovenski
Valkommen, valj ditt sprak!
Svenska
Udvozoljuk, kerjuk valassza ki a nyelvet!
Magyar
Automatic channel scan (Retune)
Bem-vendo, favor selectionar seu idioma
Portugues
Choose region
Tervetuloa, valitse kielesi!
Suomi
Please wait. This will take a few minutes. Scanning digital channels: UHF 22
Multiple regional variants have been detected.
Select Language
Set Language
Please choose your preferred region.
OK
8. You will now be asked if you want to start
Cambs & Beds: BBC TWO HD
Cambs & Beds: Channel 4 HD
Country
UK
the automatic channel scan. Press the
Cambs & Beds: BBC ONE HD
2. Press the buttons to select your country.
Cambs & Beds: ITV HD
Primary region
Any
buttons to highlight Yes and press OK.
Cambs & Beds: BBC THREE HD
Secondary region
Cambs & Beds: CBBC HD
Any
Tertiary region
Any
First time installation
Channels Found :
6
OK
Welcome!
Cancel scan
Country
<
UK
>
MENU
Search Type
Digital only
2. Press the button to highlight Secondary
Do you want to start an automatic
Teletext Language
West
channel
region, then press the buttons to select
Scan Encrypted Channels
Yes
Yes
No
your Secondary Region e.g. London.
3. Press the button to highlight Tertiary
Please ensure your aerial is plugged in before tuning in your TV
region, then press the buttons to select
Select Language
Choose your country
OK
OK
Start search
your Tertiary Region e.g. Greater London.
4. Press the button to highlight OK then
3. Press the button to highlight Search Type,
Automatic channel scan (Retune)
press OK. Your TV is now fully tuned in.
then press the buttons to select Digital
Please wait. This will take a few minutes. Scanning digital channels: UHF 22
Only. This will only search for the digital
5. The Edit Channel list will appear, press the
EXIT button to remove this. Your TV is now
channels.
Cambs & Beds: BBC TWO HD
Cambs & Beds: Channel 4 HD
fully tuned in and ready to use.
Cambs & Beds: BBC ONE HD
4. Press the button to highlight Teletext
Cambs & Beds: ITV HD
Cambs & Beds: BBC THREE HD
Language, then press the buttons to
Cambs & Beds: CBBC HD
Edit Channel List
select your language. The majority of people
1. BBC ONE Lon
DTV
TV
Channels Found :
6
2. BBC TWO
DTV
TV
will want this set to West.
3. ITV
DTV
TV
5. Press the button to highlight Scan
MENU
Cancel scan
4. Channel 4
DTV
TV
5. Channel 5
DTV
TV
Encrypted Channel (pay-per-view channels),
6. ITV2
DTV
TV
7. BBC THREE
DTV
TV
then press the buttons to select Yes
9. BBC FOUR
DTV
TV
10. ITV3
DTV
TV
or No.
OK
Move
Delete
Edit name
Lock
Function
Navigate
Filter
OK
Watch
MENU
Cancel scan
RET.BACK
Back
0....9
Jump
P+
P-
Page UP/DOWN
Well done,
your new TV is now ready to use. You will find that there are many exciting features available. To get to know all these features, please take
some time to read the instruction manual provided with your TV.
(QSG-LT-32C345/46(C)-150827V1)
27/08/2015 14:47
1
2
3
.,/@
4
5
6
7 7 7
7 7
7
7
8
9
0
V
P
V
P
MENU
Q.MENU
OK
BACK
EXIT
/
/
LANG.
RM-C3182
Remote Control /
AAA Batteries x 2
7
Advertisement
Table of Contents
