Table of Contents
Advertisement
5. Insert the three metal studs on the base into the corresponding holes in the new monitor stand. Then,
rotate the bottom cover of the base to display the screw
stand.
Figure 18. Installing the monitor stand to the base
6. Insert the two tabs
as shown. Then, pivot the monitor stand downward and install the two screws to secure the monitor
stand to the computer.
Figure 19. Installing the monitor stand
Replacing the UltraFlex II Stand
To replace the UltraFlex II Stand, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
56
Lenovo S500z User Guide
1
on the new monitor stand into the corresponding holes in the computer cover
1
and tighten the screw to secure the monitor
Advertisement
Table of Contents
