Makita AN451 Instruction Manual page 9

1
2
1. Graduation
2. Arrow
3. Coil support plate
1. Feed Claw
2
1. Air fitting
2. Air socket
Lift and turn the coil support plate so that the arrow with nail
005627
size indicated on the coil support plate will point to the corre-
sponding graduation increment marked on the magazine. If
the tool is operated with the coil support plate set to the
wrong step, poor nail feed or malfunction of the tool may
result.
3
Place the nail coil over the coil support plate. Uncoil enough
005628
nails to reach the feed claw. Place the first nail in the driver
channel and the second nail in the feed claw. Place other
uncoiled nails on feeder body. Close the magazine cap after
checking to see that the nail coil is set properly in the maga-
zine.
1
Connecting air hose
005631
Slip the air socket of the air hose onto the air fitting on the
1
nailer. Be sure that the air socket locks firmly into position
when installed onto the air fitting. A hose coupling must be
installed on or near the tool in such a way that the pressure
reservoir will discharge at the time the air supply coupling is
disconnected.
9