Assembly - Ariens PB936 Owner's/Operator's Manual

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Tools Required:
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16" and/or Adjustable Wrench
• Tire Gauge
• 5/32" Hex Driver
Unpacking Unit
WARNING: Dropping or tipping
over boxed unit could result in
personal injury or damage to unit.
Handlebar and Shift Rod
1. Remove lower wing knobs on handlebar
assembly (Figure 3).
2. Remove upper wing nut and bolt on shift
rod.
3. Loosen upper wing knobs on handlebar.
4. Loosen lower wing nut and bolt on shift
rod.
5. Put speed selector lever into fastest
reverse panel notch.
6. Rotate handlebar up so wing knob holes
align. Install and tighten all wing knobs.
7. Install wing nut and bolt removed in step
2 onto shift rod and tighten hardware.

ASSEMBLY

2
1. Speed Selector
Lever
2. Attachment
Clutch Lever
3. Upper Wing Nut
4. Lower Wing Nut
5. Shift Rod
Check Function of Dual Handle
Interlock
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage. If they do not, contact your dealer
for repairs.
Check Tire Pressure
Check tire pressure and adjust to the pressure
listed on tire sidewall.
Check Engine Crankcase Oil
IMPORTANT: Engine is shipped with 5W-30
oil in crankcase. Refer to Engine Manual for
detailed instructions.
GB - 9
8
1
4
6. Lower Wing
7. Upper Wing
8. Drive Clutch
Figure 3
5
7
6
3
Knob
Knob
Lever
OS3020