Ariens PB936 Owner's/Operator's Manual page 13

7. Reinstall the adjustment pins at the new
position.
8. Repeat steps 1- 7 until proper adjustment
is attained.
3
2
1
1.Swept Area
2.Caster Wheel
Figure 6
FUEL SHUT-OFF VALVE
IMPORTANT: The fuel shut-off valve MUST
be in the closed position prior to transporting
the unit.
The fuel shut-off valve has two postions:
• Closed Position: Use this postion to
service, transport, or store the unit.
• Open Postion: Use this postion to run
the unit.
FILLING FUEL TANK
To add fuel to the tank:
1. ALWAYS place unit in an open, well-
ventilated area.
2. Stop engine and allow to cool.
WARNING: FLAMMABLE FUEL
and its EXPLOSIVE VAPORS can
result in death or serious injury.
Handle fuel with extreme care.
ALWAYS use an approved fuel
container. NO Smoking! NO Lighted
Materials! No Open Flames! Allow
engine to cool before any service.
3. Clean fuel cap and surrounding area to
prevent dirt from entering the fuel tank.
4. Remove cap.
IMPORTANT: See engine manual for correct
type and grade of fuel to use.
5. Fill fuel tank to within 1/2 inch (1.27 cm)
below bottom of filler neck. Tank capacity
is 4.0 qts (3.8 liters).
6. Replace fuel cap and tighten.
2-3 in
(5.08-7.6 cm)
OS0061
3.Height Adjusting
Pin
7. ALWAYS clean up any spilled fuel.
PRE-START
1. Check Engine Air Cleaner Position
(Climate Guard)
IMPORTANT: See Engine Manual for correct
orientation of air cleaner cover prior to starting
engine.
2. Check Function of Clutches
Brush must stop quickly when attachment
clutch lever is released.
Wheels must stop quickly when traction drive
clutch lever is released.
If clutches do not engage or disengage
properly, adjust or repair before operation (see
Service and Adjustments).
3. Check Dual Handle Interlock
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage.
If clutches do not engage or disengage
properly, adjust or repair before operation (see
Service and Adjustments).
4. Differential Lock
Engage differential lock (located in left wheel
hub) for best traction.
5. Adjust Brush
Adjust brush height and angle before
operation. See Brush Adjustments.
GB - 13
This side out for use ABOVE
32°F (0°C).
This side out for use BELOW
32°F (0°C).