Preparation - Beko 674580 EDI User Manual

4

Preparation

For a freestanding appliance; 'this
refrigerating appliance is not intended
to be used as a built-in appliance' ;
Your refrigerator should be installed at
least 30 cm away from heat sources
such as hobs, ovens, central heater
and stoves and at least 5 cm away
from electrical ovens and should not
be located under direct sunlight.
The ambient temperature of the room
where you install your refrigerator
should at least be 10°C. Operating
your refrigerator under cooler
conditions is not recommended
with regard to its efficiency.
Please make sure that the interior of
your refrigerator is cleaned thoroughly.
If two refrigerators are to be installed
side by side, there should be at least
2 cm distance between them.
When you operate your refrigerator
for the first time, please observe
the following instructions
during the initial six hours.
The door should not be
opened frequently.
It must be operated empty
without any food in it.
Do not unplug your refrigerator. If
a power failure occurs out of your
control, please see the warnings
in the "Recommended solutions
for the problems" section.
Original packaging and foam
materials should be kept for future
transportations or moving.
The baskets/drawers that are
provided with the chill compartment
must always be in use for low
energy consumption and for
better storage conditions.
Food contact with the temperature
sensor in the freezer compartment
may increase energy consumption
of the appliance. Thus any contact
with the sensor(s) must be avoided.
In some models, the instrument panel
automatically turns off 5 minutes
after the door has closed. It will
be reactivated when the door has
opened or pressed on any key.
Due to temperature change as a
result of opening/closing the product
door during operation, condensation
on the door/body shelves and
the glass containers is normal
Since hot and humid air will not
directly penetrate into your product
when the doors are not opened,
your product will optimize itself in
conditions sufficient to protect your
food. In this energy saving function,
functions and components such
as compressor, fan, heater, defrost,
lighting, display and so on will operate
according to the needs to consume
minimum energy while maintaining
the freshness of your foodstuff.
In case of multiple options are present
glass shelves must be placed so that
the air outlets at the backwall are
not blocked, prefably air outlets are
remaining below the glass shelf. This
combination may help impoving air
distribution and energy efficiency.
13
EN