Installation; Points To Be Paid Attention To When The Relocation Of The Refrigerator; Electrical Connection - Beko 674580 EDI User Manual

3

Installation

B
In case the information which are
given in the user manual are not
taken into account, manufacturer
will not assume any liability for this.
Points to be paid attention
to when the relocation of the
refrigerator
1. Your refrigerator should be
unplugged.Before transportation
of your refrigerator, it should
be emptied and cleaned.
2. Before it is re-packaged,
shelves, accessories, crisper, etc.
inside your refrigerator should
be fixed with adhesive tape and
secured against impacts. Package
should be bound with a thick
tape or sound ropes and the
transportation rules on the package
should be strictly observed.
3. Original packaging and
foam materials should be kept for
future transportations or moving.
Before you start the refrigerator,
Check the following before you
start to use your refrigerator:
4. Clean the interior of the
refrigerator as recommended in the
"Maintenance and cleaning" section.
5. Connect the plug of the
refrigerator to the wall socket.
When the fridge door is opened,
fridge internal lamp will turn on.
6. When the compressor starts to
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give rise
to noise, even if the compressor is
not running and this is quite normal.
7. Front edges of the refrigerator
may feel warm. This is normal.
These areas are designed to be
warm to avoid condensation.

Electrical connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection must be in compliance
with national regulations.
The power plug must be easily
accessible after installation.
Electrical safety of your refrigerator
shall be guaranteed only if the
earth system in your house
complies with standards.
The voltage stated on the label
located at left inner side of
your product should be equal
to your network voltage.
Extension cables and multi plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated
before it is repaired! There is
the risk of electric shock!
10
EN