B Hex Bolt, 3/8" X 1; D Nylock Nut, 1/4 - Agri-Fab 45-01012 Owner's Manual

9. Assemble the front panel over the end of the cart using
four 1/4" x 5/8" hex bolts and 1/4" nylock nuts as shown
in figure 5. Leave two holes shown in figure 5 empty
in the bottom of the panel. Pull the cart body halves
together and tighten the two bolts in the bottom of the
front panel, then tighten the bolt in each side.
At this time tighten the three bolts in the bottom of the
cart which were assembled in step 4.
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
1/4" NYLOCK NUT
FIGURE 5
10. Assemble the wheel support to the cart using eight 5/16"
x 3/4" truss head bolts and 5/16" nylock nuts as shown
in figure 6. Heads of bolts go to the inside of cart bed.
Tighten.
WHEEL
SUPPORT
5/16"
NYLOCK
NUT
FIGURE 6
1/4" x 5/8"
HEX BOLTS
1/4" NYLOCK NUT
5/16" x 3/4"
TRUSS HEAD BOLT
11. Turn the latch stand bracket so that the aligning tab is
at the rear (bottom) of the bracket. Assemble the latch
stand bracket to the cart using four 1/4" x 5/8" hex bolts
and 1/4" nylock nuts. TIGHTEN. See figure 7.
LATCH STAND BRACKET
ALIGNING TAB
AT BOTTOM
1/4" NYLOCK NUT
FIGURE 7
12. Assemble the two corner caps to the front corners of
the cart using four 1/4" x 5/8" hex bolts and 1/4" nylock
nuts. Also assemble two 1/4" x 5/8" hex bolts and 1/4"
nylock nuts to the two rear corners of the cart. TIGHTEN.
See figure 8.
CORNER CAP
1/4" x 5/8"
HEX BOLT
FIGURE 8
5
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK NUT
1/4" NYLOCK
NUT