Kärcher K 3.600 Manual page 17

5 Appliance switch "0/OFF"/ „I/ON"
6 Dosage regulator for detergent
7 Storage for trigger gun
8 Transport handle, detachable
9 Storage for high-pressure hose
10 Storage of detergent reservoir with deter-
gent connection
11 Storage for accessories
12 Storage hook for mains connection cable
13 Detergent reservoir with locking lid
14 Mains cable with mains plug
15 Wheels
16 Trigger gun
17 Lock trigger gun
18 Key to detach the high-pressure hose
from the trigger gun
19 Spray lance with pressure regulation
(Vario Power)
20 Spray lance with Dirtblaster
21 Washing brush
22 Rotary washing brush
23 Delta-Racer D150
Special accessories
Special accessories expand the possibilities
of using your appliance. Please contact your
KÄRCHER dealer for further information.
Before Startup
Mount loose parts delivered with appliance
prior to start-up.
Install wheels
Illustration
Push the wheels into the intake and se-
cure with the enclosed plugs, watch for
positioning of plug.
Install the storage for hand-spray gun
Illustration
Place the bottom holder into the recesses
and push forward until it audibly lcoks in.
Insert the top holder and push down all
the way.
Install the storage hook for the mains
connection cable
Illustration
Press in the storage hook and lock it into
the top position.
Install the transport handle
Illustration
Place the transport handle into the intake
until you feel resistance. Use the heel of
your hand or a soft rubber mallet to posi-
tion it.
Install the dosage regulator for detergent
You will need the 2 included screws as well as
a Philips screwdriver PH 2.
Illustration
Insert both detergent hoses onto the hose
fittings.
Install the dosage regulator and connect
using 2 screws.
Note: During installation you must make
sure that the tongues of the dosage regu-
lator match up with the intended recesses
in the casing.
Connect the high pressure hose to the
hand spray gun
Illustration
Push the high pressure hose into the trig-
ger gun until it locks audibly.
Note: Make sure the connection nipple is
aligned correctly.
Check the secure connection by pulling
on the high-pressure hose.
Warning
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is consid-
ered non-drinkable.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For
protection, the use of the KÄRCHER water fil-
ter (optional accessory, order no. 4.730-059)
is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/techni-
cal data.
- 4
EN
Water supply
13