NEC MultiSync E244FL Setup Manual page 12

Do not place this product on a sloping or unstable cart, stand or table.
Doing so could lead to falling or tipping and cause personal injury.
9
PROHIBITED
Do not insert objects of any kind into the cabinet slots.
It may cause electric shock, fire, or product failure. Keep objects away from children and
babies.
PROHIBITED
If objects get into the cabinet slot, turn off the product's power, then unplug the power cord
10
from the power outlet. Contact your dealer for repairs.
HAZARDOUS
VOLTAGE
Do not spill any liquids into the cabinet or use your product near water.
Immediately turn off the power and unplug your product from the wall outlet, then refer
11
servicing to qualified service personnel. It may cause an electric shock or start a fire.
DO NOT WET
Do not use flammable gas sprays to remove dust when cleaning the product.
Doing so could lead to a fire.
12
PROHIBITED
Usage of the product must not be accompanied by fatal risks or dangers that, could lead
directly to death, personal injury, severe physical damage or other loss, including nuclear
13
reaction control in nuclear facility, medical life support system, and missile launch control in a
PROHIBITED
weapon system.
Handling the power cord.
Handle the power cord with care. Damaging the cord could lead to fire or electric shock.
• When connecting the power cord to the product's AC IN terminal, make sure the connector
is fully and firmly inserted.
REQUIRED
• Make sure the power cord cannot be easily disconnected.
• Do not connect or disconnect the power cord with wet hands.
• When connecting or disconnecting the power cord, pull the power cord out by holding onto
DO NOT TOUCH
its plug.
WITH WET
• When cleaning the product, for safety purposes, unplug the power cord from the power
HANDS
outlet beforehand. Regularly dust off the power cord by using a soft dry cloth.
1
• Before moving the product, make sure the monitor power is off, then unplug the power cord
from the power outlet and check that all cables connecting the product to other devices are
disconnected.
UNPLUG THE
• When you are not planning to use the product for an extended period of time, always unplug
POWER CORD
the power cord from the power outlet.
• This equipment is designed to be used in the condition of the power cord connected to the
earth.
If the power cord is not connected to the earth, it may cause electric shock. Please make
HAZARDOUS
sure the power cord is connected to the wall outlet directly and earthed properly. Do not use
VOLTAGE
a 2-pin plug converter adapter.
Please confirm the distribution system in building installation shall provide the circuit breaker
rated 120/240 V, 20 A (maximum).
2
REQUIRED
WARNING
CAUTION
English-4