Table of Contents
Advertisement
3 Insert the new memory module in the slot:
a Push the retaining clips on the slot out to the sides.
b Align the notch on the gold edge of the module with the notch in the memory slot.
c Push down on the memory module with firm and even pressure. The retaining clips will snap into position as
the module is correctly inserted.
Important:
• For normal operations, you must insert your memory modules into the white slots first.
• You must utilize the same type of memory on all slots. The default memory is non-ECC, UDIMM DDR4.
If you expand utilizing ECC, UDIMM DDR4 memory, you must remove the original.
• Hold the memory module by its edges, and do not touch the gold connectors.
Note:
• When memory capacity is changed, the device will perform a memory check upon the next start up. This will
prolong the start up time by up to ten minutes. This behavior is normal and will only occur once.
4 Put back the rear top cover you lifted in step 2.
a Align the round dots at the side of rear top cover with the slots on the chassis' edge, and push the rear top
cover back in position.
b Put back and fasten the screw you removed in step 2-a.
To make sure RackStation recognizes the new memory capacity:
1 Log in to DSM as admin or a user belonging to the administrators group.
2 Check
Total Physical Memory
If your RackStation does not recognize the memory or does not start up successfully, confirm that the memory is
installed correctly.
10 Chapter 2: Hardware Setup
in
Control Panel
>
Info
Center.
Advertisement
Table of Contents
