3. Place the lug slots of your new carbon
filters into the lugs on the motor holder
and turn them clockwise to snap them
into place.
6 Troubleshooting
If the problem persists after following the
instructions in this section, contact your
vendor or an Authorized Service. Never try
to repair your product yourself.
Product is not working.
• Fuse may be faulty or blown. >>> Check
the fuses in the fuse box. Change them if
necessary or reactivate them.
• The product may not be plugged in. >>>
Check if the product is plugged in to the
outlet or not.
• The speed button may not be set. >>>
Press/touch the desired speed button.
• There may be no electricity. >>> Ensure
the mains is operational and check the
fuses in the fuse box. Change the fuses
if necessary or reactivate them.
Hood light is not on.
• Hood lamp may be faulty. >>> Contact
your local dealer where you purchased
your product or the Customer Service,
and ensure that the lamp is replaced.
• There may be no electricity. >>> Ensure
the mains is operational and check the
fuses in the fuse box. Change the fuses
if necessary or reactivate them.
4. Close the hood glass cover after in-
stalling the aluminium filter.
"Hob to Hood" function is not working.
(For model B)
• Hood or hob control panel might be
covered with an object. >>> Remove the
object and reactivate the function over
the hob.
• You might be using a pot which might
block the signal between the hob and the
hood. >>> Place your pot onto the hob in
such a way not to block the signal.
EN / 18