Sharp UX-1100 Service Manual page 7

4
Take the new film out of its package, and insert the three gears
and the flange into the ends of the spools as shown. Make sure
that the tabs on the gears and the flange fit properly into the slots
in the ends of the spools.
•
The flange has one tab, and the gears each have 2 tabs.
•
Do not yet remove the band which holds the spools together.
1 tab
Flange
Gear
2 tabs
5
Hold the empty spool so that the flange is on the left, and lower
the spools into the front of the printing compartment so that the
gears in the ends of the spool with the film fit into the slots on
each side of the printing compartment.
6
Cut the band which holds the spools together with scissors, and
remove it.
7
Pull the empty spool toward the back of the compartment, unwind-
ing the blue leader from the spool with the film as you pull.
1 slot
Gears
2 slots
8
Insert the empty spool into the back of the compartment so that
the gear and the flange fit into the slots on the sides of the
compartment.
•
Make sure that the gear engages with the gear below it.
9
Wind the film slightly (rotate the gear on the right side of the
empty spool) so that there is no slack in the film. Make sure that
both edges of the film wind onto the spool evenly.
F
Rotate the printing head frame back down, and press down on the
"PUSH" mark in the center of the frame until the frame clicks into
place. Close the printing compartment cover.
G
Initialize the film counter by pressing the FUNCTION key, the "6"
key, and the "#" key on the operation panel. Make sure that "INI-
TIALIZE FILM" appears in the display, and then press the START
key.
•
You must initialize the film counter to make the machine wind
the film to the starting position for printing. If this is not done,
the first pages you print will come out blank.
F U N C T I O N
1 – 5
UX-1100DE
FO-1450DE
6
S T A R T