Sundance Spas 880 Series Owner's Manual page 93

Filter/
circulation
pump off
PROBLEM
Poor jet
action
(Sections
9.1-9.22,
pages
21-42)
Water is too
hot
No heat
Should checking the above steps fail to correct the problem, please call
your authorized dealer so that he may arrange service.
Sundance builds the best hot tubs in the industry. Nonetheless, we are
always striving to improve the quality and features of our products. Your
input as a Sundance hot tub owner is a cherished part of this process. If
you have any comments or suggestions, or if you wish to be informed on
any new products for your hot tub, please write to us.
CONGRATULATIONS on your good taste and welcome to the happiest
and most relaxed family in the world!
1. Verify filter/circulation pump is programmed to run 8
hours a day (page 59).
2. Hot tub water is warmer than 95°F (35°C) and
2°F (1°C) warmer than the set temperature. The
"Summer Logic" safety feature has activated.
PROCEDURE
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (pages 69-71).
1. Reduce thermostat setting (page 17).
2. Switch hot tub to "Economy" mode to turn heater on
only during programmed filter cycles (page 58).
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If "heater on" indicator is lit but no temperature rise
is experienced after a reasonable period of time,
contact your Sundance Spas dealer or qualified
service technician.
880 Series
87