Philips S7882 Manual page 13

'Unplug for use' symbol
How do I use my appliance?
4 Insert the USB supply unit into the wall socket.
- While the appliance is in quick charge mode, the
lights of the battery status indicator light up one
after the other. After approximately 5 minutes, the
bottom light of the battery status indicator flashes.
The battery now contains enough energy for one
full shave.
- While the appliance charges, first the bottom light
of the battery status indicator flashes and then
lights up continuously. Next the second light
flashes and then lights up continuously, and so on
until the appliance is fully charged.
- When the appliance is fully charged, all three
battery indicator lights light up continuously. After
approx. 30 minutes, the light goes out
automatically.
5 After charging, remove the USB supply unit from the
wall socket, pull the USB plug out of the supply unit
and then pull the small plug out of the appliance.
The 'unplug for use' symbol flashes to remind you to
disconnect the appliance from the wall socket and
remove the small plug from the appliance before you
switch it on.
Warning: Always check the appliance and all
accessories before use. Do not use the appliance
or any accessory if it is damaged, as this may cause
injury. Always replace a damaged part with one of
the original type.
Note: This appliance is waterproof. It is suitable for use in
the bath or shower and for cleaning under the tap. For
safety reasons, the appliance can therefore only be used
without cord.
13
English