QSC CXD-Q Series User Manual page 8

Parallel Channels Bridged (AB + CD)
For One Loudspeaker
Full power to one loudspeaker
Use one 2-wire cable, connect to:
• T1+/T5-
Connect the Loudspeakers
1. Connect the loudspeaker wiring to the 8-pin Euro-style connector as needed for
your amplifi er's confi guration.
2. Install the female 8-pin Euro-style connector onto the male connector on the rear of
the amplifi er as shown in Figure
3. Use a Phillips screwdriver to secure the connector.
AC Power On
After connecting the outputs to the loudspeakers, you may turn the amplifi er on.
1. Make sure the output gain settings for all audio-source devices (CD Players, Mixers,
Instruments, etc.) are at the lowest output (max attenuation).
2. Turn on all audio sources.
3. Turn the AC Mains power switch on the back of the amplifi er to ON. The amplifi er
starts in the state it was in when power was removed. If the amplifi er is in Standby
or Mute All mode (Power button LED solid red or blinking), press the Power button
to change the amplifi er to Run mode.
4. You can now bring up the outputs of your audio sources.
TD-000438 -01 -A
CHANNEL CONFIGURATION
Q AB+CD
1 Channel: AB+CD
Channel Configuration Locked to Design
— Figure 12 —
13.
OUTPUTS TO SPEAKERS
8
PARALLEL CHANNEL
COMBINING APPLICATIONS
CH AB
SETTINGS CAN BE
+
T1 T2
CONFIGURED FOR
+
T3 T4
70V, 100V AND
200V DIRECT
CH CD
OUTPUT.
+
T5 T6
+
T7 T8
BRIDGED
+
CH A B
CH ABC
+ -
T1 T3 +
T2
T1
+
T3 T4
+
CH C D
+
T5 T6
+ -
T5 T7
CH ABCD
+
CH AB CD
+
T1 T2
+ -
T1 T5 +
T3 T4
+
T5 T6
+
T7 T8
— Figure 13 —
-
-
-
-
-
-
-
-
-
-
-