UNIVIEW IPB5E40X Quick Manual page 3

scratch and contamination, etc. In order to keep the cover clean, do
not remove the protective film on the cover during mounting. After
mounting is finished, remove the film before the device is powered
on.
Contact professionals for maintenance information. Do not attempt

to dismantle the device by yourself. We shall not assume any
responsibility for problems caused by unauthorized repair or
maintenance.
Maintenance
Caution: There will be risk of explosion if battery is replaced by an

incorrect type. Dispose of used batteries according to the
instructions.
If there is dust on the front glass surface, remove the dust gently

using an oil-free brush or a rubber dust blowing ball.
If there is grease or a dust stain on the front glass surface, clean the

glass surface gently from the center outward using anti-static gloves
or an oil-free cloth. If the grease or the stain still cannot be removed,
use anti-static gloves or an oil-free cloth dipped with detergent and
clean the glass surface gently until it is removed.
Do not use organic solvents, such as benzene or ethanol when

cleaning the transparent dome cover.
Never look at the transmit laser while the power is

on. Never look directly at the fiber ports and the
fiber cable ends when they are powered on.
Use of controls or adjustments to the performance

or procedures other than those specified herein
may result in hazardous laser emissions.
2