Table of Contents
Advertisement
To align the device, turn the device
2.
feet. Check alignment with a spirit
level.
All device feet must stand firmly
on the floor.
Hand-tighten the lock nuts against
3.
the housing using a SW17 wrench.
Hold the base of the device and
do not adjust the height.
4.7 Connecting the device
electrically
A notice:Your domestic electrical
installation for this device must
comply with local statutory provisions
and safety regulations.
and should have one
circuit breaker included
residual current
in.
Set up and connecten
Plug the mains plug of the device's
1.
power cord into a socket near the
device.
The connection data of the device
can be found in the technical data
→ page 54 .
Check that the mains plug is firmly
2.
seated.
17
Advertisement
Table of Contents
