enSet up and connect
WARNING
Risk of injury!
When operating on a base, the device
can tip over.
▶ Before using the device for the first
time on a base, be sure to fasten it
with the retaining tabs → page 30 of
the manufacturer.
ATTENTION!
Freezing residual water in the
device can damage the device.
▶ Do not set up and operate the device
in areas where there is a risk of frost
or outdoors.
If the device is tilted more than 40°,
residual water in the device may leak
and cause property damage.
Tilt the device carefully.
▶
▶
Transport the device in an upright position.
location
base
wooden beam ceiling
14
requirements
The device with
retaining tabs
→ page 30 be
consolidate.
The device on a
water-
standing wooden
plate (strength
at least 30 mm)
put up that
firmly to the floor
is screwing.
location
kitchenette
On a wall
4.4 Remove transport locks
The device is secured for transport
with transport locks on the back of
the device.
A notice:Keep the screws of the
transport locks and the sleeves for
later transport → page 51 on.
Pull the hoses out of the holders.
1.
requirements
The device only
under
hender working
put up a plate
which are fixed to
the neighboring
connected
is. Required
niche width:
60 cm.
No hoses
and mains
final line
between wall
and device
jam.