Bosch WGG2440R10 Instructions For Use And Assembly page 46

enTroubleshooting
Disturbance
Repeated
fling.
Change program duration
changes during the
washing process.
Water is not visible
in the drum
bar.
Drum jerks
program start.
In the chamber
there is residual
ser.
vibration and movement
the appliance during
spinning.
drum turns,
Water doesn't run in.
46
Cause and troubleshooting
Imbalance control system compensates for imbalance by
distributing the laundry several times.
No error - no action necessary.
▶
A notice:When loading, put as large and small items of
laundry as possible together in the drum. Items of
laundry of different sizes spread out better when
spinning.
Program flow is electronically optimized. This can lead
to a change in the program duration.
No error - no action necessary.
▶
Imbalance control system compensates for imbalance by
distributing the laundry several times.
No error - no action necessary.
▶
A notice:When loading, put as large and small items of
laundry as possible together in the drum. Items of
laundry of different sizes spread out better when
spinning.
Foam control system switches on a rinse cycle if the
foam builds up too much.
No error - no action necessary.
▶
Water is below the visible range.
No error - no action necessary.
▶
Do not add additional water to the device during
▶
operation.
The cause is an internal engine test.
No error - no action necessary.
▶
be
Insert in chamber is clogged.
→ "Cleaning the detergent drawer", page 36
▶
Device is not aligned correctly.
→ "Align device", page 16
▶
Device feet are not fixed.
Fix the device feet.
▶
→ "Align device", page 16
Transport locks are not removed.
→ "Remove transport locks", page 14 .
▶
Load detection is active.
No error, no action necessary.
▶
A notice:The load detection can take up to 2 minutes.