Connection With The Mains; Operation; Stand Alone-Mode; Control Board - EuroLite LED PAR-64 RGBW 48x3W IP65 User Manual

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED PAR-64 RGBW 48 x 3 W starts running.
The LED display lights up and you can choose the desired mode via the buttons MENU, UP, DOWN and
ENTER.
Attention: After every 8 PAR-64 RGBW 48 x 3 W, the fixtures must have a renewed connection with the
power mains.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.

- STAND ALONE-MODE

• Setting Solid Colors
• Internal Programs
- DMX MODE
Stand Alone-Mode
In the Stand Alone mode, the LED PAR-64 RGBW 48 x 3 W can be used without controller.
Disconnect the LED PAR-64 RGBW 48 x 3 W from the controller.

Control Board

The Control Board offers several features: you can simply set the starting address or run the internal
programs.
Browse through the main menu by pressing Menu. You can change the selection by pressing Up or Down.
Confirm every selection by pressing the Enter-button. The functions provided are described in the following
sections. You can leave every mode by pressing the Menu-button.
Setting the DMX Start Address:
Mode:
d
International
L
N
Value:
1 - 512
20/24 00056640.DOC, Version 1.3