Handset Sound Signals; Troubleshooting Guide; Telephone Solutions; No Dial Tone - RCA TC25211 User Manual

2-line dect 6.0 cordless handset telephone with dect 6.0 cordless headset
Table of Contents

Advertisement

PAGE FROM BASE Someone pressed the PAGE button on the base.
UNKNOWN

Handset Sound Signals

Signal
A long warbling tone (with ringer on)
Three short beeps (several times)
One beep every 14 seconds

Troubleshooting Guide

Telephone Solutions

No dial tone

• Check or repeat installation steps:
Make sure the base power cord is connected to a working electrical outlet. Make sure the
telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack. If it doesn't work, the problem might be your
wiring or local service.
• The handset may be out of range of the base. Move closer to the base.
• Make sure the battery is properly charged (for 14 hours).

Dial tone is ok, but can't dial out

• Make sure the type of phone service you are subscribed to is TONE or PULSE.

Handset does not ring

• Make sure the handset ringer is set to on.
• The handset may be out of range of the base. Move closer to the base.
• You may have too many extension phones on your line. Try unplugging some extensions.
• Check for a dial tone. If no dial tone is heard, see "No dial tone".
You experience static, noise, or fading in and out
• The handset may be out of range of the base. Move closer to base.
• Make sure base is not plugged into an electrical outlet with another household appliance.
If necessary, relocate the base.
• Charge the battery (for 14 hours).

Memory dialing doesn't work

• Did you follow proper dialing sequence?
Indicates incoming call is from an area not serviced by CID or the CID
information was not sent.
Meaning
Signals an incoming call
Page signal
Low battery warning
31

Advertisement

Table of Contents
loading

Table of Contents