Problem Identification - Master XL6 User And Maintenance Book

►►10. PROBLEM IDENTIFICATION
PROBLEM
Generator 1. Generator blocked
doesn't run 2.The power switch is in the "OFF"
(0) position
3. No power
4. Feeder cable unplugged
5. Blocked control card
6. Wrong thermostat setting
7. Temperature sensor override
8. Fuse damaged
Motor/pump 1. No fuel
runs but the
flame does 2. Ignition device is dirty
not start 3. Fuel filter is dirty
4. Nozzle is dirty
5. Photocell is dirty, damaged or
installed improperly
6. Foreign substances present in
the tank
7. Electrodes are used up or
placed at an improper distance
Fan blocked 1. Engine damaged
or spins too
slowly
POSSIBLE CAUSE POSSIBLE SOLUTION
1. Restart the generator
2. Turn the switch "ON" (|)
3A. Plug the feeder cable properly into
the socket
3B. Check the power supply network
3C. Contact the technical service center
4. Contact the technical service center
5A. Restart the generator
5B. Identify the display error
5C. Contact the technical service center
6. Calibrate the thermostat by setting it
higher than ambient temperature
7A. Wait at least ten minutes then try to
run ignition again
7B. Contact the technical service center
8. Contact the technical service center
1. Turn off the generator, refill the fuel
tank then restart the generator
2. Contact the technical service center
3. Clean the filter using clean fuel
4. Contact the technical service center
5. Contact the technical service center
6. Empty and refill the fuel tank with
clean fuel
7. Contact the technical service center
1. Contact the technical service center
en
it
de
es
fr
nl
pt
da
fi
no
sv
pl
ru
cs
hu
sl
tr
hr
lt
lv
et
ro
sk
bg
uk
bs
el
zh