Maintenance Procedure - Master XL6 User And Maintenance Book

►►8. DISPLAY ERRORS
en
See B Fig. 3
it ERROR
de
F0
1. The "ON/OFF" switch is turned
es
"ON" (|) when the generator is
plugged in
fr
nl
F1
1. No fuel
pt
2. Fuel is contaminated
da
fi
no
3. Photocell is dirty or damaged
sv
4. Fuel filter is dirty
5. Ignition error
pl
F2
ru
1. Interrupted cable
2. Sensor is damaged
cs
hu F3
1. Internal generator overheating
sl
2. Antitilting sensor intervent
tr
LO
1. External temperature below 0°C
hr
CH
1. Continuous operation
lt
►►9. PREVENTIVE MAINTENANCE SCHEDULE
lv
WARNING: BEFOR INITIATING ANY REPAIR OR MAINTENANCE PROCEDURE UNPLUG
et
THE FEEDER CABLE AND MAKE SURE THAT THE GENERATOR IS COOLED DOWN.
COMPONENT
ro
Fuel tank
sk
bg
Nozzle
uk
Photocell
bs
Fuel filter
el
zh
Ignition device
Fan blades
CAUSE
TEMPERATURE CONTROL SENSOR ERROR
MAINTENANCE FREQUENCY
Clean every 150-200 hours of
operation or when necessary
Clean or replace once per season or
when necessary
Clean once per season or when
necessary
Clean or replace twice per season or
when necessary
Clean or replace every 1.000 hours
of operation, or when necessary
Clean when necessary
OPERATION ERROR
1. After disconnecting the generator,
see that the switch is in the "OFF" (0)
position, plug the generator in and turn
the switch "ON" (|)
PHOTOCELL ERROR
1. Turn the switch "OFF" (0), refill the fuel
tank
2. Turn the switch "OFF" (0) empty and
refill the fuel tank. Clean the filter using
clean fuel, do not damage the filter (SEE
PARA. 6)
3. Contact the technical service center
4. SEE PARA. 6
5. Contact the technical service center
1. Contact the technical service center
2. Contact the technical service center
THERMOSTAT ERROR
1. Turn the generator off, wait until it is
cooled down
2. Place the heater on a level and stable
surface
1. Normal condition
1. Normal condition

MAINTENANCE PROCEDURE

Empty and rinse with fresh fuel
Contact the technical service center
Contact the technical service center
Clean the fuel filter with clean fuel
Contact the technical service center
Contact the technical service center
SOLUTION