Securing The Camera To The Ceiling - Bosch NDP-5512-Z30C-P Installation Manual

16 en | Installing an In-ceiling Camera in a Suspended Ceiling
7.4

Securing the Camera to the Ceiling

1.
2.
3.
4.
Warning!
Over torquing the ceiling clamps can damage the clamp or ceiling. Only tighten the clamp
!
until it contacts the ceiling and you start to feel some resistance. If using a power
screwdriver, set the torque level to the lowest setting.
5.
2020-04 | 2.0 |
Connect the cables from the ceiling to the cables on the camera. Refer to the chapter
Connection for more information.
Insert the camera (without the trim ring / bubble enclosure) into the hole in the ceiling.
Ensure not to pinch the cables.
Turn each fastening screw to secure the clamps in the ceiling.
Tighten the clamps using the Phillips screwdriver to secure the housing to the ceiling.
Place the trim ring / bubble enclosure in position over the camera block, aligning the
three (3) screws. Tighten the screws firmly to secure the trim ring / bubble enclosure to
the in-ceiling bracket.
3×
Installation Manual
AUTODOME IP starlight 5000i
Bosch Security Systems